Connected: An Internet Encyclopedia
3.2.7 Telnet Binary Option: RFC-856

Up: Connected: An Internet Encyclopedia
Up: Requests For Comments
Up: RFC 1123
Up: 3. REMOTE LOGIN -- TELNET PROTOCOL
Up: 3.2 PROTOCOL WALK-THROUGH
Prev: 3.2.6 Telnet Command Structure: RFC-854, p. 13
Next: 3.2.8 Telnet Terminal-Type Option: RFC-1091

3.2.7 Telnet Binary Option: RFC-856

3.2.7 Telnet Binary Option: RFC-856

When the Binary option has been successfully negotiated, arbitrary 8-bit characters are allowed. However, the data stream MUST still be scanned for IAC characters, any embedded Telnet commands MUST be obeyed, and data bytes equal to IAC MUST be doubled. Other character processing (e.g., replacing CR by CR NUL or by CR LF) MUST NOT be done. In particular, there is no end-of-line convention (see Section 3.3.1) in binary mode.

DISCUSSION:

The Binary option is normally negotiated in both directions, to change the Telnet connection from NVT mode to "binary mode".

The sequence IAC EOR can be used to delimit blocks of data within a binary-mode Telnet stream.


Next: 3.2.8 Telnet Terminal-Type Option: RFC-1091

Connected: An Internet Encyclopedia
3.2.7 Telnet Binary Option: RFC-856